vtz file matching the version of ShowRunner that is installed will need to be extracted from the ShowRunner. Legacy installations of ShowRunner do not have the new ShowRunner landing page, and thus the XPanel installer will need to be downloaded and installed separately. ShowRunner Installations v2.200 and Older The method used and required IP settings for the computer will vary by location, however if it was possible to access the XPanel through a Web browser before, then it will be possible to access the XPanel using one of the methods described below. Connect to the Lighting NetworkĪs with accessing the XPanel through a Web browser, it is necessary to be connected to the lighting network.
#Crestron xpanel installer.air how to
See the Chief Integrations ShowRunner UI Guide for more information on how to use this interface. The UI for this XPanel is the same as the old web XPanel UI and the UI on any TSW touch panels. (Note, ShowRunner Reports and Management will still be available.) Instead, the XPanel must be accessed using an alternate method depending on which version of ShowRunner is currently running on the processor. Prior to 2021, it has been possible to access the ShowRunner XPanel (a virtual touch panel interface) by connecting a laptop or computer to the lighting network and navigating to from a Flash-enabled Web browser (where "(ProcessorIpAddress)" is replaced with the processor's IP Address).Īfter December 2020, Flash will no longer function, meaning that it will no longer be possible to access the XPanel in this way.
0 kommentar(er)
